And in all reality, you’ve actually shortened the serviceable life of your battery. I used it and its working good for my phone. Channel Catalog Subsection Catalog. We thought we might be able to read a device ID – or some other factory-loaded register – to simply verify that the HDQ interface is working on a unit under test, using the BQA with minimal connections to the IC 3. How do I actually get the ID? After a great time in Vancouver, Collaborans are headed this weekend to southern France to attend and speak at the edition of Capitole…. Note, the DesignCapacity is around mAh.
|Date Added:||18 February 2004|
|File Size:||70.21 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
We have been trying to run the calibration cycle for a long time with little or no success.
Update Status doesn’t go liux 1 and Qmax doens’t updated. Whether writing a line of code or shaping a longer-term strategic software development plan, we’ll help you navigate the ever-evolving world of Open Source.
During the last year I have noticed some faulty battery packs where some of the cells are discharged more than others creating imbalance and malfunction. I have also attached in the.
As one year ends and another begins, Collabora is proud to be once again an Includer sponsor for the latest round 17 of Outreachy internships,….
Llinux hope you can help me find out why the calibration cycle is not working properly. I want to use an eq34zevm with an 6-cell li-po battery.
[PATCH 2/5] power: sbs-battery: rename internals to new name
Android Apps and Games. If one battery damaged, no change to circuit, remaining batteries operate as usual. How do I do this?
We have currently an issue with this following gauge meter: Hi I want to use an eq34zevm with an 6-cell li-po battery.
[PATCH 2/4] power: bq20z75: add i2c retry mechanism
Our products must initialize the as qb20z75 customer may deplete battery charge fully to Vbat shutoff and memory loss on the chip power bank application. Which empirical fact are you disputing? Do you really feel that the remainder of the document describes these well enough for someone to accomplish without further help?
Posting Quick Reply – Please Wait.
Add MAX Fuel Gauge Driver – Initial Release 
Power management forum – Recent Threads http: Channel Catalog Subsection Catalog. Any ideas as to why the SOC is so far off even after performing the learning cycles. I want to write a golden image file to the bq And really had the effect. I am being asked to provide a standardized list of 5 SOC thresholds for our products to then rely upon.
By marosigeSenior Member lknux 6th April I discharge the battery to linix. Are you a developer? Dear all, We are still using the bq20z75 V.
I have expected that once the battery voltage becomes lower than the Shutdown voltage set to 8. I know that linuc optimal thing would be to increase the value of the sense resistor to use the full range of the ADC but that part of the system is fixed because it is part of the enclosure itself.
I also calibrated the voltage. We thought we might be able to read a device ID – or some other factory-loaded register – to simply verify that the HDQ interface is working on a unit under test, using the BQA with minimal connections to the IC 3.
[v2] power supply: add driver for TI BQ20Z75 gas gauge IC – Patchwork